Setting Exposure Compensation
68
Custom Function C.Fn-6-2 enables the exposure compensation amount to be
set in 1/2-stop increments. (→p.102)
The exposure compensation amount’s 1/2-stop increments enabled with C.Fn-6
are indicated in the viewfinder and on the LCD panel as shown below.
• The exposure compensation amount will remain in effect even after the < >
switch is set to < >.
• To prevent the < > dial from turning inadvertently and changing the exposure
compensation amount, set the < > switch to < >.
–1 1/2 exposure compensation
Exposure Compensation with the < > Button and < > Dial
2
Press the < > button and turn
<> dial within ( ) to set the
desired exposure compensation
amount.
To Next Page
Loading...
