122
Troubleshooting Guide
If there is a problem, first refer to this Troubleshooting Guide. If the problem
still persists, take the camera to your nearest Canon Service Center.
Canon Service Centers are listed on the back of this booklet.
Nothing is
displayed
on the LCD
panel.
The camera’s
Custom
Function
cannot be set.
AF does not
work when
the shutter
button is
pressed
halfway.
The shutter
does not
work.
<> is < >.
Set the < > switch to < >. (
→p.14)
The battery is exhausted.
Replace the battery with a new one. (
→p.19, 20)
The battery has been installed incorrectly.
Install the battery correctly. (
→p.19)
<> is < >.
Set the < > switch to < >. (→p.14)
The < > switch is < >.
Set the < > switch to < >. (
→p.17)
<> is < >.
Set the < > switch to < >. (
→p.14)
The lens focus mode is set to
MF (or M).
Set the lens focus mode to
AF (or A). (→p.21)
C.Fn-4 is set to 1 or 3.
Set C.Fn-4 to 0. (
→p.100)
The < > icon blinks on the LCD panel.
Take out the film and load it correctly. (→p.25, 26)
The < > icon blinks on the LCD panel.
Replace the battery. (
→p.19)
The < > icon blinks while the rewound film is still in the
camera.
Replace with a new roll of film. (
→p.28, 25)
The in-focus indicator in the viewfinder blinks and focus
cannot be achieved.
Select another focusing point. (
→p.38) If focus still cannot
be achieved, focus manually. (
→p.48)
SEC.09 P119-142 (E) 29-01-2003 12:40 Pagina 122
To Next Page
Loading...
Need help?
General
