Canon EOS 3000D - Troubleshooting Guide

282
If a problem occurs with the camera, first consult this Troubleshooting
Guide. If this Troubleshooting Guide does not resolve the problem,
contact your dealer or nearest Canon Service Center.
 Do not use any battery other than a genuine Canon Battery Pack
LP-E10.
 If the battery charger has a problem, the protection circuit will stop the
charging and the charge lamp will blink in orange. If this happens,
unplug the charger’s power plug from the power outlet and detach the
battery. Attach the battery to the charger again and wait a while before
connecting the charger to a power outlet again. If the problem persists,
contact your dealer or nearest Canon Service Center.
 Make sure the battery is properly installed in the camera (p.36).
 Make sure the card slot/battery compartment cover is closed (p.36).
 Recharge the battery (p.34).
 Press the <B> button (p.54).
 If the power is turned off while an image is being recorded to the card,
the access lamp will remain on/continue to blink for a few seconds.
When the image recording is completed, the power will turn off
automatically.
Troubleshooting Guide
Power-Related Problems
The battery does not recharge.
The battery charger’s lamp blinks.
The camera does not operate even when the power
is turned on.
The access lamp still lights or blinks even when the power
is turned off.