Canon EOS A2 - Page 46

46
Auto exposure bracketing is carried out in
each mode as follows:
P: Both the shutter speed and aperture value
are shifted.
Av, DEP, M: Only the shutter speed is shifted.
Tv, X: Only the aperture value is shifted.
3) Set the command dial to the desired
shooting mode and take pictures.
e To cancel auto exposure bracketing, re-
peat steps 1 and 2 to reset the bracketing
amount to 0.
e Auto exposure bracketing is automatically
canceled when the battery is replaced.
e Auto exposure bracketing cannot be used
in bulb mode or when using flash.
e Auto exposure bracketing can be used in
X mode or manual mode with flash units
connected through the PC terminal.
e The exposure level blinks in the LCD
panel and viewfinder display during auto
exposure bracketing operation.
If you wish to shift the bracketed exposure
values toward over- or underexposure, you
can add exposure compensation using the
quick control dial. In this case the LCD panel
may not display the correct values, but expo-
sures will be made correctly.