Canon imagePROGRAF iPF755 User Manual

Note
• Even if there is a NetWare server in your network environment, you can use it in conjunction with TCP/
IP or AppleTalk. In this case, complete the settings for each protocol you will use.
Configuring the IP Address on the Printer
You must configure the printer's IP address before using the printer in a TCP/IP network.
The printer's IP address is configured automatically when you install the printer driver following the instructions in the Set-
up Guide.
Configure the IP address by using imagePROGRAF Device Setup Utility, the printer Control Panel, or ARP or PING com-
mands, if the IP address is changed, or if you change the printer connection mode to a network connection. For details on
configuring the IP address, refer to the following topics.
• Configuring the IP Address Using imagePROGRAF Device Setup Utility
→P.403 (Windows)
• Configuring the IP Address Using the Printer Control Panel →P.756
• Configuring the IP Address Using ARP and PING Commands →P.758
Important
• If you use a DHCP server for automatic assignment of the printer's IP address, printing may no longer be
possible after the printer is turned off and on. This is because an IP address different from before has been
assigned. Thus, when using DHCP server functions, consult your network administrator and configure the
settings in one of the following ways.
• Configure the setting for dynamic DNS updating
In RemoteUI, activate the setting Enable DNS Dynamic Update. (See "Configuring the Printer's TCP/
IP Network Settings.")
→P.760
• Configure the setting for assignment of the same IP address each time the printer starts up
Note
• We recommend configuring the printer's IP address even if you will use the printer in networks other than
TCP/IP networks. Configuring the printer's IP address enables you to use RemoteUI to configure the network
settings and manage the printer with a web browser.
For details on RemoteUI, see "Using RemoteUI." →P.759
Configuring the IP Address Using the Printer Control Panel
This topic describes how to configure the printer's IP address on the Control Panel.
1. On the Tab Selection screen of the Control Panel, press ◀ or ▶ to select the Settings/Adj. tab (
).
Note
• If the Tab Selection screen is not displayed, press the Menu button.
Network Setting > Network Setting >
Configuring the IP Address on the Printer iPF755
10
756

Canon imagePROGRAF iPF755 Specifications

General

Printer Type	Large Format Printer
Maximum Print Resolution	2400 x 1200 dpi
Number of Ink Colors	5
Number of Nozzles	15, 360
Memory (Standard)	256 MB
Hard Drive	80 GB
Ink Droplet Size	4 picoliters
Operating Systems	Windows, Mac OS
Print Technology	Inkjet
Ink Type	Pigment/Dye
Maximum Print Width	36 inches
Connectivity	USB, Ethernet
Media Handling	Roll Feed
Media Width	8 inches to 36 inches
Media Thickness	0.07 - 0.8mm
Ink Colors	Cyan, Magenta, Yellow, Black
Media Sizes	Roll paper: 10"-36" (254mm-914mm), Cut sheet: 8"-36" (203.2mm-914mm)
Media Types	Plain Paper, Coated Paper, Photo Paper
Power Consumption	140W or less
Print Speed (Color)	D-sized print (33.1 x 23.4 inches) in approximately 28 seconds
Print Speed (Black & White)	D-sized print (33.1 x 23.4 inches) in approximately 28 seconds