Note
• If you specify to configure the IP address using DHCP, BOOTP, or RARP, there must be a server that sup-
ports such protocol running in the network.
• If you specify to configure the IP address using DHCP, BOOTP, or RARP, the IP address obtained by this
method is used first. If you cannot obtain the IP address, the address specified in IP Address is used.
• It takes up to two minutes to determine whether DHCP, BOOTP, or RARP are available. We recommend
clearing check boxes of options you will not use.
• If you are using a DNS server, select Enable DNS Dynamic Update and enter the IP Address for DNS serv-
ers and DNS domain name in Primary DNS Server Address, Secondary DNS Server Address and DNS
Domain Name, respectively.
When using an IPv6 IP address
1. Start the web browser and enter the following URL in the Location (or Address ) box to display the RemoteUI
page.
http://printer IP address or name/
Example: http://xxx.xxx.xxx.xxx/
2. Select Administrator Mode and click Logon.
3. If a password has been set on the printer, enter the password.
4. Click Network in the Device Manager menu at left to display the Network page.
5. Click Edit in the upper-right corner of the TCP/IPv6 group to display the Edit TCP/IPv6 Protocol Settings page.
6. Refer to the TCP/IPv6 Settings Items table to complete the settings.
TCP/IPv6 Settings Items
Item Details Default Setting
Use IPv6 Activate to enable IPv6. Off
Use DHCPv6 Activate when using a DHCPv6 server to acquire the
IP address.
Off
Use a stateless address Activate when using an IPv6-compatible router to ac-
quire the IP address.
On
Use a manual address Activate when configuring the IP address manually. Off
IP Address Enter the printer's IP address. ::
Prefix Length Enter the IP address prefix length. 0
Default Router Ad-
dress
Enter the default router address. ::
Prefix Length Enter the prefix length of the default router address. 0
Primary DNS Server Address Specify the IP address of the primary DNS server. ::
Secondary DNS Server Address Specify the IP address of the secondary DNS server. ::
Use the same host name and do-
main name as IPv4
Activate when using the same DNS host and domain
names as for IPv4.
Off
Network Setting
>
Network Setting
>
Configuring the Printer's TCP/IP Network Settings iPF755
10
762
To Next Page
Loading...
Need help?
General
