Chapter 3
3-13
5) With the media take-up sensor unit against the underside of the bottom stand stay and the right stand leg, insert M4 hex screws in the three holes [1] and slide
the screws out of the way toward the narrow end of the protruding holes. Insert M4 hex screws in the small holes [2] as well. Than, tighten all five M4 hex screws
firmly in the order shown from (2) to (6).
F-3-22
Arrange the basket cloth and basket rod so they do not interfere with the media take-up sensor (indicated by the dotted line).
F-3-23
To Next Page
Loading...
