Chapter 3
3-36
3.2.2 Reinstalling the Printer
3.2.2.1 Reinstalling the Printer
0020-5722
1. Installing after transporting by LEVEL 0 or LEVEL 1.
If ink drainage was not performed when transporting by LEVEL 0 or 1, remove the belt stopper and attach the power cord and interface cable after moving the
printer to the installation location, and then check the operation of the printer (with test pattern).
2. Installing after transporting by LEVEL 2 or LEVEL 3.
If ink drainage was performed when transporting by LEVEL 2 or LEVEL 3, follow the installation procedure which is nearly identical to the procedure when in-
stalling for the first time.
To Next Page
Loading...
Need help?
General