Chapter 7
7-1
7.1 Service Mode
7.1.1 Service Mode Operation
0013-9799
a. How to enter the Service mode
Enter the Service mode following the procedure below.
1) Turn off the printer.
2) Turn on the printer while holding down the [Paper Source]key and [Information]key.
3) "S" will be displayed in the upper right corner of the display showing the firmware version of the printer.
4) After display of "Online", pressing the [Menu] key displays the SERVICE MODE top menu and the MESSAGE LED flashes.
* The Service mode is added to the options in the Main menu. The Service mode can be entered even in the error status(when an error message is shown on the
display)by turning the power off and then using the above key operation.
b. How to exit the Service mode
Turn off the printer.
c. Key operation in the service mode
- Selecting menus and parameters:[ ] or [ ] key
- Going to the next lower-level menu:[ ] key
- Going to the previous higher-level menu:[ ] key
- Determining a selected menu or parameter:[OK] key
To Next Page
Loading...
Need help?
General