To Next Page

To Previous Page

Chapter 2

2-6

2.2.2 Operation Sequence at Power-off

0012-6311

Turning off the power switch cuts off the drive voltage supply, launching a firmware power-off sequence as shown below.

If the power cord is disconnected from the wall outlet or the upper cover or any other cover is opened, the printer cancels the ongoing operation and shuts down

immediately. Since printhead capping may or may not have been carried out properly, reconnect the power cord to the wall out and turn on the power switch. Making

sure that the printer has entered online mode, turn off the power switch.

1. Power-off sequence

F-2-6

Power button OFF

If media remains,it is ejected even

when printing is in progress.

Media ejection

Power-off automatic recovery

Capping

Sensor system power OFF

Backup of various data

Power-off