3-3. Adjustment and Settings in Service Mode
(1) Service mode operation procedures
Use the Service Tool on the connected computer.
1) Start the printer in the service mode.
i. With the printer power turned off, while pressing the Resume/Cancel button, press and hold the ON button.
(DO NOT release the buttons.)
ii. When the Power LED lights in green, while holding the ON button, release the Resume/Cancel button. (DO
NOT release the ON button.)
iii. While holding the ON button, press the Resume/Cancel button 5 times, and release the ON button. (Each
time the Resume/Cancel button is pressed, the Alarm and Power LEDs light alternately, Alarm in orange
and Power in green.)
iv. When the Power LED lights in green, the printer is ready for the service mode operation.
2) Start the Service Tool on the connected computer.
i. When a button is clicked in the Service Tool dialog box, that function is performed. During operation of the
selected function, all the Service Tool buttons are dimmed and inactive.
ii. When the operation is completed, "A function was finished." is displayed, and another function can be
selected.
iii. If a non-supported function is selected, "Error!" is displayed. Click OK in the error message dialog
box to exit the error.
To Next Page
Loading...
