4. VERIFICATION AFTER REPAIR
4-1. Standard Inspection Flow
In each step below, confirm that printing is performed properly and the printer operates properly without any
strange noise.
iX6500 series TABLE OF CONTENTS
EEPROM information print
<Check point>
- The information must be printed properly.
<Additional verification to be made> See 2-1. Major Replacement Parts and
Adjustment.
- At logic board replacement
- At absorber kit replacement
- At platen unit or spur unit replacement
Integrated inspection pattern print
<Check point>
- The pattern must be printed properly.
Communication with a connected PC
<Check point>
- Via USB connection to the PC, printing from the PC must be performed properly
(paper feeding from the rear tray).
Power-off in the service mode
<Check point>
- The paper lifting plate must be in the raised position.
External and internal appearance
<Check point>
- No grease, oil, or smearing on the timing slit strip film.
- No lifting of the platen ink absorber.
- No foreign material or dislocation of any part inside the printer.
- No damage or scratches that will affect the functionality.
Packaging
<Check point> See 6. MACHINE TRANSPORTATION.
- The carriage must be locked in the home position.
To Next Page
Loading...
