Canon iX6540 - Page 8

head.
7 times Multiple ink tanks
of the same color
installed.
[1487] Replace the wrong ink tank(s)
with the correct one(s).
- Ink tank
Ink tank in a
wrong position.
[1680] Install the ink tank(s) in the
correct position.
- Ink tank
8 times Warning: The ink
absorber becomes
almost full.
[1700] Replace the ink absorber, and
reset its counter. [See 3-3,
Adjustment and Settings in
Service Mode.]
Pressing the Resume/Cancel
button will exit the error, and
enable printing without replacing
the ink absorber. However, when
the ink absorber becomes full, no
further printing can be performed
unless the applicable ink
absorber is replaced.
- Absorber kit
11 times Failed in automatic
print head
alignment.
[2500] Press the Resume/Cancel button
to clear the error, then perform
the automatic print head
alignment again. (Use plain
paper.)
If the alignment pattern was not
printed properly (faint printing,
etc.), perform print head
cleaning, then perform the print
head alignment again.
- Carriage unit
- Print head
- Purge drive system unit
12 times Premium Contents
print error.
[4100] Non-genuine ink tanks are
installed. Install the supported
(Canon-genuine) ink tanks.
- Ink tank
13 times The remaining ink
amount unknown
(raw ink present).
[1683] An ink tank which has once been
empty is installed. Replace the
applicable ink tank with a new
one. Printing with a once-empty
ink tank can damage the printer.
To continue printing without
replacing the ink tank(s), press
the Resume/Cancel button for 5
sec. or longer to disable the
function to detect the remaining
ink amount. After the operation,
it is recorded in the printer
EEPROM that the function to
detect the remaining ink amount
was disabled.
- Ink tank
- Spur unit
4 / 52