Canon LBP 3370 - Page 288

8-29
Tr oubleshooting
8
Message List
<26 SYS.MEM.FULL> <Auto Error Skip>
Cause The work memory required for the printer process has run out while the
system is processing the data (mainly the graphics data and text data).
Remedy 1 The printer continues printing by pressing the (Online) key. However, the
data with which an error has occurred is not printed properly.
Remedy 2 Perform a soft reset using the RESET menu, and then increase the free space
of RAM using the following procedure.
• Perform a hard reset or cycle the power of the printer (Be aware that all the
data in the memory will be deleted).
<27 JOB START ERR> <Auto Error Skip>
Cause The specified emulation does not exist.
Remedy Press the (Online) key to continue printing from the next data. However, the
data with which an error has occurred is not printed.
<30 MEMORY FULL> <Auto Error Skip>
Cause The work memory has run out while the system is processing the data.
Remedy The printer continues printing by pressing the (Online) key. However, the
data with which an error has occurred may not be printed properly.
<32 2-SIDED ERROR> <Auto Error Skip>
Cause The printer received 2-sided printing data of paper sizes (including the
orientation) or paper types unavailable for automatic 2-sided printing.
Remedy 1 The printer continues printing by pressing the (Online) key. However, the
data on each side is printed on two pages.
Remedy 2 After performing a soft reset in the RESET menu, change the setting to a paper
size or type available for automatic 2-sided printing, and then print again.
<33 WORK MEM.FULL> <Auto Error Skip>
Cause The work memory for each print mode cannot be secured.
Remedy 1 The printer continues printing by pressing the (Online) key. However, the
data with which an error has occurred is not printed properly.
IMPORTANT
When you continue printing by pressing the (Online) key , be aware that the data of
macro that is already registered may be deleted.