Canon LBP 3370 - Page 289

8-30
Tr oubleshooting
8
Message List
Remedy 2 Perform a soft reset in the RESET menu, increase the free space of RAM using
the following procedure, and then print again.
• Perform a hard reset or cycle the power of the printer (Be aware that all the
data in the memory that the printer has received will be deleted).
<35 TABLE FULL> <Auto Error Skip>
Cause The number of the documents in a job has exceeded 16.
Remedy The printer continues printing by pressing the (Online) key. However, the
job with which an error has occurred is not printed.
<38 LOW IMGE QLTY> <Auto Error Skip>
Cause The printer cannot process the data because it is too complicated.
Remedy 1 The printer continues printing by pressing the (Online) key. However, the
printer prints with the image quality level being lowered.
Remedy 2 Perform a soft reset in the RESET menu, set GRADATION LEVEL (See p. 6-24)
in the QUALITY MENU options in the SETUP menu to STANDARD, and then
print again.
<39 SPL MEM.FULL> <Auto Error Skip>
Cause Because spool memory has run out, the printer cannot print.
Remedy 1 The printer continues printing by pressing the (Online) key. However, the
page with which an error has occurred is not printed.
Remedy 2 Perform a soft reset in the RESET menu, specify the paper size smaller, and
then print again.
Remedy 3 Perform a soft reset in the RESET menu, set GRADATION LEVEL (See p. 6-24)
in the QUALITY MENU options in the SETUP menu to STANDARD, and then
print again.
Remedy 4 If 2-SIDED PRINT. in the FEEDER MENU options in the SETUP menu is set to
ON, specify OFF, and then print again.
Remedy 5 Change the setting for HALFTONES (See p. 6-26) in the QUALITY MENU
options in the SETUP menu, and then print again.