Additional Information 155
Cannot divide the scene. Initialize only using the camcorder.
- The scene could not be divided because the camcorder’s internal scene management data log
is full. Save your recordings ( 121) and initialize the memory ( 39). Write back the
backup files and try dividing the scene again.
Cannot edit
- Could not move a scene in the playlist.
Cannot enter standby mode now
- The camcorder cannot enter standby mode if the remaining battery charge is too low.
Cannot play back
- There is a problem with the memory.
Cannot play back Cannot access the built-in memory
- There is a problem with the built-in memory.
Cannot play back Check the memory card
- There is a problem with the memory card.
Cannot play the movies in the built-in memory Initialize only using the camcorder
- The camcorder's built-in memory was initialized using a computer. Initialize the built-in mem-
ory with this camcorder ( 39).
Cannot play the movies on this memory card
- Movies cannot be played back from a 64 MB or smaller memory card.
Cannot play the movies on this memory card Initialize only using the camcorder
- The memory card in the camcorder was initialized using a computer. Initialize the memory
card with this camcorder ( 39).
Cannot record
- There is a problem with the memory.
Cannot record Cannot access the built-in memory
- There is a problem with the built-in memory.
Cannot record Check the memory card
- There is a problem with the memory card.
Cannot record movies in MXP/FXP mode on this memory card
- Movies cannot be recorded in MXP or FXP mode on a memory card if it is rated Speed Class
2. Select a different recording mode ( 42) or replace the memory card with one rated
Speed Class 4 or 6.
Cannot record movies in the built-in memory Initialize only using the camcorder
- The camcorder's built-in memory was initialized using a computer. Initialize the built-in mem-
ory with this camcorder ( 39).
To Next Page
Loading...
