160 Additional Information
Too many photos. Disconnect the USB cable.
- Disconnect the USB cable. Try using a memory card reader or decrease the number of photos
on the memory card to fewer than 2,500 photos.
- If a dialog box appeared on the computer screen, close it. Disconnect the USB cable, and
restore the connection after a short while.
Transfer order error
- You attempted to set more than 998 transfer orders. Reduce the number of photos marked
with transfer orders.
Unable to recognize the data
- You transferred data to the camcorder recorded in a different television system (NTSC).
Unable to recover data
- Could not recover a corrupted file.
Messages Related to the Optional DW100 DVD Burner
If an error message appears while the camcorder is connected to the
optional DW-100 DVD Burner, refer to the following section and also to
the instruction manual of the DVD Burner.
Cannot read the disc. Check the disc.
- During disc recording mode, this message can appear when a commercially available DVD
disc (a DVD disc containing movies, software, etc.) or an 8 cm mini DVD disc is inserted.
- During disc playback mode, this message can appear when a commercially available DVD
disc or a brand new DVD disc is inserted.
Close the memory card slot cover
- The memory card slot cover is open. Close the cover after correctly inserting the memory card
( 38).
Connect the compact power adapter
- The camcorder is being powered by the battery pack. Connect the compact power adapter to
the camcorder.
Disc access failure. Check the disc.
- There was an error when reading the disc or attempting to write onto it.
- This message can appear also if condensation has formed ( 169). Wait until the DVD
burner dries completely before resuming use.
- The disc may not be loaded correctly. Try removing the disc and reinserting it.
Error reading the data
- An error occurred while reading the recordings from the camcorder.
- Check that the USB cable was not accidentally disconnected.
To Next Page
