Important
•
When loading a roll, be careful to avoid hitting the printer hard with the roll. This may damage the
Roll Holder.
4.
If using 3-inch core roll paper, attach 3-Inch Paper Core Attachment to holder stopper.
Align the tabs (A) of the attachment with the holes (B) of the holder stopper, and insert firmly.
5.
Insert holder stopper from left into Roll Holder as shown, and while holding in position (B),
push firmly until holder stopper flange (A) touches roll paper. Lift holder stopper lever (C)
from shaft to lock.
46
To Next Page
Loading...
