178
This explains functions common to video detection.
Configuring Operations for “Detected” ([Event] Tab)
Set operations to be performed upon detection of changes in a subject.
(1) Specify Operation Timing (Multiple Selections Possible)
[ON Event Operation]
When selected, the operations set in (2) are performed when the mode becomes “detected”.
[OFF Event Operation]
When selected, the operations set in (2) are performed when “detected” mode ends.
[Detected mode Operation]
When selected, the operations set in (2) are performed while “detected” mode is active.
(2) Specify Event Operation (Multiple Selections Possible)
[E-mail Notification]
When selected, e-mail notification is sent according to the timing set in (1). [Video Record] > [E-mail Notification] on
the Setting Page must be set in advance (P. 148).
[Video Record]
When selected, video recording begins according to the timing specified in (1). [Video Record] > [Upload] (P. 144) or
[Memory Card] > [Video Record Settings] (P. 196) on the Setting Page must be set in advance.
(3) Specify Audio Playback Timing
[Audio Playback at ON Event]
When selected, the sound clip specified in (4) is played back when the mode becomes “detected”.
[Audio Playback at OFF Event]
When selected, the sound clip specified in (4) is played back when “detected” mode ends.
(4) Sound Clip Settings
[Sound Clip Name]
Select the sound clip to be played back. You must register the sound clip with Sound Clip Upload 1 to 3 (P. 137) in
[Video and Audio] > [Audio] on the Setting Page in advance.
[Event] > [Intelligent Function]
- Shared Operations -
HM4x
H730
H730
To Next Page
Loading...
