Canon WFT-E8A - Page 86

86
Basic Linked Shooting
Set up the master camera by operating the camera to use as the
master.
7
Select [Master].
 Perform steps 1 to 5 on page 84 for
the master camera, then select
[Master].
 Select [OK] and press <0> to go to
the next screen.
8
Select [Auto connect].
 Select [OK] and press <0> to go to
the next screen.
 To set manually, see page 91.
Operate the slave cameras and master camera to connect them.
9
On the slave cameras, select
[OK].
 On all slave cameras, select [OK].
 On the master camera’s LCD monitor,
the number of slave cameras
detected is displayed.
10
On the master camera, select
[OK].
 Check the number of slave cameras,
then select [OK].
Preparing the Master Camera
Connecting the Cameras