Canton Smart Series - Page 33

3
33
English
• [LIP] / [LIP SYNC]
Delay of the audio signal in case of non lip-synchronous playback
• [VOL] / [MAX VOLUME]
Adjust maximum system volume
• [ASM] / [ANALOG STEREO MODE]
Connecting the ANALOG LINE Signal L+R to one [SST] or seperatly to
both [DST] Smart speakers
• [SLC] / [SLAVE CONNECTION]
Wireless [WLS] or wired [WRD] connection between speakers
• [LAN] / [LANGUAGE]
Setting the menu language as German or English
• [RES] / [RESET]
Restore factory settings. Attention: After the reset, the master and slave
speakers must be reconnected (paired).
[WIS] / [WIRELESS SETUP]
• [WSP] / [WIRELESS PAIRING]
Pairing additional wireless speakers (p. 34)
• [TXP] / [RF POWER]
Transmit power wireless module: [ECO]=25%, [MED]=50%, [MAX]=100%
• [CHN] / [CHANNEL SELECT]
RF channel wireless module: auto or channel 1–3 at 2.4/5.2/5.8 GHz band
• [BT] / [BLUETOOTH]
• [BTP] / [BT PAIR]
Automatic (permanent) or manual pairing of (mobile) devices
• [BTS] / [BT SELECT]
Automatic or manual selection of the input [BT]
• [APL] / [BT AUTO PLAY]
Automatic playback after switching on the Smart speakers
• [BRE] / [BT RESET]
Deleting all settings and paired (mobile) devices
[INF] / [INFORMATION]
• [MCU] / [STS]
Info about firmware version of controller [MCU] and wireless module [STS]