CanyCom S160 - Page 70

-61-
Troubleshooting
6
Area Malfunction Possible Cause Corrective Measure Ref.
Engine
Engine overheats.
Insufcient amount of
engine oil.
→Fill oil. Page 41
Insufcient amount of
engine coolant.
→Fill coolant. Page 41
Radiator or cooling fan is
clogged or blocked.
→Clean.
Other (other than the
above).
→Please contact
your CANYCOM
representative.
Excessive fuel
consumption.
Clogged air cleaner. →Clean or replace air
cleaner element.
Page 43
Other (other than the
above).
→Please contact
your CANYCOM
representative.
Black smoke comes out
of exhaust.
Bad fuel. →Change fuel.
Clogged air cleaner. →Clean or replace air
cleaner element.
Page 43
Other (other than the
above).
→Please contact
your CANYCOM
representative.
Black smoke comes out
of exhaust.
Engine oil level is too
high.
→Adjust oil level.
Other (other than the
above).
→Please contact
your CANYCOM
representative.
Accelerator lever is
catching.
Faulty wire, rod, or
linkage.
→Please contact
your CANYCOM
representative.
Drive Train
Machine does not move
(forward, backward,
turning) when steering
levers are in the
corresponding position.
Clutch is not engaged. →Engage clutch. Page 23
Parking brake is applied. →Release parking
brake.
Page 20
Excessive load. →Reduce load.
Insufcient or
deteriorated HST uid.
→Add or change uid. Page 47
Other (other than the
above).
→Please contact
your CANYCOM
representative.
Irregular noise or heat is
observed at or around
track.
→Please contact
your CANYCOM
representative.