Need help?Do you have a question about the Carbide 3D Shapeoko Proximity Switch Kit and is the answer not in the manual?
General| Brand | Carbide 3D |
|---|---|
| Model | Shapeoko Proximity Switch Kit |
| Category | Switch |
| Language | English |
Steps and considerations before starting the proximity switch installation process.
Lists the necessary tools and materials for the upgrade procedure.
Instructions for safely disconnecting all electrical cables from the machine.
Guide on routing the new proximity switch cables through the drag chain.
Mounting the proximity switch to the X-axis carriage.
Mounting the proximity switch to the Y-axis carriage.
Mounting the proximity switch to the Z-axis.
Connecting motor lead cables to their extension cables.
Plugging proximity switch and motor cables into the Carbide Motion board.
Steps and considerations before starting the HDZ proximity switch installation.
Lists the necessary tools and materials for the HDZ upgrade.
Instructions for disconnecting cables and removing the X-axis belt on HDZ.
Mounting proximity switches to the HDZ X and Z axes.
Routing the new proximity switch cables through the drag chain for HDZ.
Attaching the proximity switches to their respective mounts on the HDZ.
Connecting motor lead cables to their extension cables for the HDZ.
Plugging HDZ proximity switch and motor cables into the Motion board.
Instructions for downloading and installing the latest Carbide Motion software.
Steps to verify that the newly installed proximity switches are functioning correctly.
Procedure to home the Shapeoko after proximity switch installation.
Steps to recalibrate the BitSetter after updating settings and homing.
To Next Page