Cardinal 220 - Page 15

14
ID (H) KEY
In the alphanumeric mode, this key is used to enter the letter “H”.
ACCUM (I) KEY
In the alphanumeric mode, this key is used to enter the letter “I”.
DELETE (J) KEY
In the alphanumeric mode, this key is used to enter the letter “J”.
COUNT/SAMPLE (L,
§
) KEY
Pressing this key during entry of alphanumeric data will
backspace and delete the last character
entered. In the alphanumeric mode, it is used to enter the letter “L”.
TIME/DATE (M, CAPS) KEY
This key is used to enter the clock mode to program the time, date and consecutive number. In
the alphanumeric mode, it is used to enter the letter “M” and to toggle between lower and upper
case alpha characters.
12 Hour Format Selected In Setup (
TIME=12
)
1. If the time displayed is correct, press the ENTER key and proceed to step 3.
2. If the displayed time is incorrect, enter the correct time and press the
ENTER
key.
3. The display will show
AM=XX
, where XX is the current setting. If the time is before noon
(12:00 PM), press the 1/YES key (display will show
AM=YES
), then press the ENTER key.
4. The display will show
DATE=XX.XX.XX
, where XX.XX.XX is the current date.
5. If the date displayed is correct, press the ENTER key to proceed to the
CNC NO=
prompt.
6. If the date displayed is incorrect, enter the correct date and press the ENTER key to
proceed to the CNC NO= prompt. Remember to enter the date in the same format (month-
day-year or day-month-year) as selected by the USA setup parameter.
24 Hour Format Selected In Setup (
TIME=24
)
1. If the time displayed is correct, press the ENTER key and proceed to step 3.
2. If the displayed time is incorrect, enter the correct time and press the ENTER key. Note that
with the 24 hour format selected, entering all times after noon (12:00 PM), you must add 12
to the time, i.e. 3 PM would be 1500.
3. The display will show DATE=XX.XX.XX, where XX.XX.XX is the current date.
4. If the date displayed is correct, press the
ENTER
key to proceed to the
CNC NO=
.prompt.
5. If the date displayed is incorrect, enter the correct date and press the ENTER key to
proceed to the
CNC NO=
prompt. Remember to enter the date in the same format (month-
day-year or day-month-year) as selected by the
USA
setup parameter.
Consecutive Number (
CNC NO=
)
If the consecutive number displayed is correct, press the ENTER key. If the consecutive
number displayed is incorrect, enter the correct number (6 digits max.) then press the ENTER
key to resume normal operation.
PRESET (N, SPACE) KEY
This key is used to enter the weight values for the Preset Weight Comparators (PWC), the
Checkweigher feature or the Digital Fill Control feature depending on which function was selected
during setup and calibration. In the alphanumeric mode, it is used to enter the letter “N” or to insert
a space between characters.
PRINT (O) KEY
In the alphanumeric mode, this key is used to enter the letter “O”.