Cardinal 220 - Setup Review

23
SETUP REVIEW
To reviewed or changed parameters without breaking the calibration seal, with the indicator ON:
1. Press the ASTERISK key, then press the ZERO/REVIEW key.
2. If the setting displayed is acceptable, press the ENTER key to save it and proceed.
3. Otherwise, enter the new setting, then press the ENTER key to save it and proceed.
4. To exit Setup Review, press the ENTER key to step through the remaining prompts
OR at
any prompt, cycle the power (press the ON/OFF key twice).
The operational parameters that can be reviewed and changed are:
LIGHT= Current Light Level
LIGHT ON=
Backlight Turn-On Level
•
The
LIGHT ON=
value must be less than
LIGHT=
to activate.
• Enter 0 for
LIGHT ON=
to have backlight always ON.
• Enter 99 for LIGHT ON= to never turn on backlight (always OFF).
FIND ETR=
View Electronic Talley Roll File
•
If
ETR able=YES
PWR UP Z=
Power Up Zero Reset Enable/Disable
TIME=
Time Format (12 or 24 hour Clock)
CLR TARE=
Clear Tare Enable/Disable
SERIAL?
Serial Input / Output Configuration (both ports)
BAUD X=
Baud Rate
PARITY X= Parity
BITS X=
Number of Data Bits
STOPS X=
Number of Stop Bits
CONT X= Continuous Output
TYPE=
Continuous Output Format (only if,
CONT X=YES
)
TABS?
Print Tab Settings
PORT= Printer Port Selection
PRT BEG
Printer Beginning
If MODE OF OP=1 (ID Storage)
TMP ID1= Temporary ID Prompt 1
TMP ID2=
Temporary ID Prompt 2
TMP ID3=
Temporary ID Prompt 3
TP TIME= Temporary Ticket Time
TP DATE=
Temporary Ticket Date
STO WT=
Temporary ID Stored Weight
ID= ID Prompt
If MODE OF OP=1 (ID Storage)
ID2=
ID Prompt 2
ID3=
ID Prompt 3