Carel MPXPRO - Page 10

10
ENG
MPXPRO - + 0300055EN rel. 1.0 30/08/10
USB/tLAN converter (IROPZTLN00)
Converter used to connect a personal computer to an MPXPRO controller
using the special connection available on the user terminals or remote
display and, with the VPM program (Visual Parameter Manager), to
complete the con guration and commissioning operations.
Fig. 1.n
USB/I2C converter (IROPZPRG00)
Converter used to connect a personal computer to an MXOPZKEYA0
programming key, so as, using the VPM program (Visual Parameter
Manager), to read, edit and write the parameters. In turn the programming
key can be used to program other controllers or read the parameters, for
example to copy the parameter settings entered on the keypad of other
controllers.
Fig. 1.o
Programming key (MXOPZKEYA0/IROPZKEYA0)
Fitted with interchangeable connectors, the MXOPZKEYA0 programming
key for MPXPRO is used to copy the complete set of parameters, storing
up to six di erent control parameter con gurations. Below is the table of
compatibility with MPXPRO  rmware versions.
Fig. 1.p
Programming key
MPXPRO  rmware
version
Sets of parameters
available
MXOPZKEYA0 ≥ 2.1 6
IROPZKEYA0 ≤ 1.2 2
Tab. 1.b
VPM programming tool (Visual Parameter Manager)
The program can be downloaded from http://ksa.carel.com. Once
running on the computer the tool can be used to commission the
controller, edit the parameters and update the  rmware. The USB/tLAN
converter is required.
Fig. 1.r
Remote control (IRTRMPX000)
The remote control is used for programming and commissioning the
MPXPRO. See the chapter on User interface.
Fig. 1.s