Need help?Do you have a question about the Carel pCO1 and is the answer not in the manual?
Describes the procedure for assigning pLAN addresses to devices.
Details control logic for inlet temperature management.
Explains control logic for outlet temperature management.
Explains essential parameters for setting up the EEV driver.
Details different operating modes for condensation control.
Explains simultaneous defrosting across units.
Describes separate defrosting between pCO units, simultaneous within a unit.
Details separate defrosting for each circuit.
Defines priority for recovery modes in summer and winter operation.
Outlines priority for using the unit in different modes.
Explains the conditions for activating free cooling.
To Next Page
General
