Basic Operating Tasks
2011-03-31 9G3886_en 2-1
2
Basic Operating Tasks
During normal operation, the laser imager receives and automatically
prints images sent by modalities over a network. Very little interaction is
required. You may do the following:
• Turn the power on (|) and off (0).
• Load film cartridges.
• Monitor the display screen for status and operating conditions.
Sometimes it will be necessary to perform preventive maintenance, filter
replacement, and other corrective actions such as a restart. (See
“Chapter 3 Maintenance and Troubleshooting”.)
You also may access the Web Portal to perform additional configuration,
optimize image quality, or do troubleshooting tasks. (See page 2-10.)
To Next Page
Loading...
