3-4 9G3886_en 2011-03-31
Maintenance and Troubleshooting
Required restart When the Restart symbol appears, you must restart before the laser
imager can continue to print.
1. Press the power switch on the back of the laser imager off (0).
2. Press the power switch on (|).
3. If the error does not clear, contact a qualified service provider.
Film jams When the Film Jam symbol appears, you must clear the jam before the
laser imager can continue to print.
See “Correcting film jams” on page 3-14 for instructions.
To Next Page
Loading...
