Film Technical Information
2011-03-31 9G3886_en 4-3
Take care when using spotlight viewing for more than 30 seconds
because temperatures near the light source may exceed 82.2° C
(180° F). Use in slide projectors is not recommended due to the high
temperatures generally found in these devices.
With dry technology, a small amount of final development occurs when
the film exits the laser imager and is initially exposed to ambient or
view-box lighting. This is virtually undetectable and has no effect on
image quality (typically 0.02 change in density). This small density
increase is uniform and permanent upon full exposure of the film under
normal handling conditions (room light or view box).
Archiving developed
film
The Laser Imaging Film has been tested and can be archived for more
than 100 years when stored at American National Standards Institute
(ANSI) recommended storage conditions (25° C or 77° F). Developed
films may be stored at higher temperatures; however, that may reduce
the number of years the film can be stored. For example, storing films at
a constant elevated temperature of 32.2° C (90°F) may reduce archive
capability to 30 years.
Exposing to moisture The Laser Imaging Films typically withstand humidity, spills, and other
forms of water without any significant effect on image quality or film
integrity. If needed, film can be cleaned with a clean, damp cloth.
Dissipating odor Dry technology eliminates virtually all unpleasant odors. While some
low-level odors are produced during the development process, they pose
no known adverse health risks. Processing odor levels are further
reduced by a non-hazardous, recyclable filter in the laser imager. This
filter traps most low-level odors and prevents them from dissipating into
the work environment. To help maintain optimum performance, the
filter requires periodic replacement. The laser imagers require no special
venting.
Dissipating heat The laser imagers use controlled heat to develop the Laser Imaging
Film. The heat has virtually no effect on the air temperature of the work
area. The amount of heat dissipated into an area during a day is typically
less than the heat generated by two to four 100-watt light bulbs.
Recycling film According to the Environmental Protection Agency (EPA) standards, the
Laser Imaging Film is not considered hazardous and requires no special
disposal procedures. However, the film does contain silver and polyester
that may be recovered by using one of several recycling processes.
To Next Page
Loading...
