51
9.2.2 - 30XB & XBP-400 & 450 - heat reclaim option
9.2.3 - 30XB-500 - heat reclaim option
ATTENTION: The condenser connection sleeves are not
installed, but supplied with the unit. The sealing joints are in
the control box. The temperature sensors and the condenser
ow switch are wired and xed in the machine. They must be
installed as described in the chapter “Condenser water
connections”.
NOTES:
- Drawings are not contractually binding.
- Before designing an installation, consult the certied
dimensional drawings, available on request.
- For the positioning of the fixing points, weight
distribution and centre of gravity coordinates please
refer to the dimensional drawings.
- If the installation includes several units or if this
(these) is (are) close to walls, please refer to chapters
3.11 - “Multiple chiller installation” and 3.12 -
“Distance to the wall” of this document to determine
the space required.
Legend
All dimensions are given in mm.
1
Required clearances for maintenance (see note)
2
Recommended space for evaporator tube removal
Water inlet for standard unit
For options 5, 6, 100A, 100C, 107 refer to the certied
drawing.
Water outlet
For options 5, 6, 100A, 100C, 107 refer to the certied
drawing.
Air outlet – do not obstruct
Power supply and control connection
A
Heat reclaim condenser
9 - HEAT RECLAIM CONDENSER OPTION (OPTION 50)
To Next Page
Loading...
