Manufacturer reserves the right to discontinue, or change at any time, specifications or designs without notice and without incurring obligations.
Catalog No. 04-53300170-01 Printed in U.S.A. Form 30MP-4T Pg CL-1 8-17 Replaces: 30MP-3T
START-UP CHECKLIST FOR 30MP LIQUID CHILLER
(Remove and use for job file.)
A. Preliminary Information
JOB NAME _____________________________
ADDRESS _____________________________
CITY ____________________ STATE ______________ ZIP ___________
MARK FOR _____________________________
INSTALLING CONTRACTOR ______________
SALES OFFICE _________________________
START-UP PERFORMED BY ______________
B. Preliminary Equipment Check (Yes or No)
Is there any shipping damage?
If so, where
Was it noted on the freight bill? YES NO
Has a claim been filed with the shipper?
YES NO
Will this damage prevent unit start-up?
YES NO
Check power supply. Does it agree with unit?
YES NO
Has the circuit protection been sized and installed properly?
YES NO
Are the power wires to the unit sized and installed properly?
YES NO
Has the ground wire been connected?
YES NO
Are all electrical terminals tight?
YES NO
System fluid volume in the loop ____________________gal (l)
Does this meet installation guide requirements?
YES NO
Water system cleaned per installation guide?
YES NO
Minimum flow rates verified per installation guide?
YES NO
In-line minimum 40-mesh strainer installed within 10 ft of the cooler/condenser water inlet?
Cooler:
YES NO
Condenser:
YES NO
Air separation / bleed devices installed per installation guide?
YES NO
NOTE: To avoid injury to personnel and damage to equipment or
property when completing the procedures listed in this start-up
checklist, use good judgment, follow safe practices, and adhere to
the safety considerations/information as outlined in preceding
sections of this Controls, Start-Up, Operation, Service and Trou-
bleshooting document.
To Next Page
Loading...
