Carrier AquaSnap 30MPA Series - Page 107

CL-7
C. Unit Start-Up (cont)
ALL UNITS:
Measure the following (measure while machine is in a stable operating condition): Check and adjust superheat as
required.
Check and adjust superheat as required.
COMMENTS:
_______________________________________________________________________________________
_______________________________________________________________________________________
_______________________________________________________________________________________
_______________________________________________________________________________________
_______________________________________________________________________________________
_______________________________________________________________________________________
_______________________________________________________________________________________
_______________________________________________________________________________________
_______________________________________________________________________________________
_______________________________________________________________________________________
_______________________________________________________________________________________
_______________________________________________________________________________________
_______________________________________________________________________________________
SIGNATURES:
START-UP TECHNICIAN ____________________________ DATE ______________________________
CUSTOMER REPRESENTATIVE ______________________ DATE ______________________________
CIRCUIT A
DISCHARGE PRESSURE (DP.A)
SUCTION PRESSURE (SP.A)
SATURATED CONDENSING TEMPERATURE (SCT.A)
SATURATED SUCTION TEMPERATURE (SST.A)
DISCHARGE LINE TEMP (D.GAS)
SUCTION LINE TEMP E (RGT.A)
COOLER ENTERING FLUID (C.EWT)
COOLER LEAVING FLUID (C.LWT)
CONDENSER ENTERING FLUID (C.DET)
CONDENSER LEAVING FLUID (C.DLT)
EXV POSITION (UNIT SIZES 050-071) (EXV.A)