Virtual BACview® application
BACview® CARRIER CORPORATION ©2021
Installation and User Guide All rights reserved
10
To navigate
To move within a screen, click the arrow keys.
To jump to another screen, do one of the following:
• Click the arrow keys to highlight a link, then click Enter.
• Click a softkey.
NOTE A [Prev] link jumps to the previous screen.
To change a property
1 Use the arrow keys to highlight the property value you want to edit.
2 Click ENTER.
NOTE If you have not previously logged in, you will be prompted for your password. See To log in (page 4).
3 Click the left or right arrow key to move the cursor under the character you want to change.
4 Do one of the following:
○ Click a number key.
○ Click the DECR or INCR softkey to cycle through binary or multi-state options or to decrease or increase a
number.
○ Click the CANCEL softkey to restore the original value.
5 Optional: To edit another property in this same screen, repeat steps 1 through 4.
6 Click the OK softkey to save all changes to the screen.
To Next Page
Loading...