Setting local schedules
BACview® CARRIER CORPORATION ©2021
Installation and User Guide All rights reserved
23
Using a BACview® device, you can set local occupancy schedules directly in a controller. These schedules can be
used in a stand-alone controller or used to start up of a network controller.
To set up schedules in a BACview® device, first define a schedule for each day of the week and then define
schedules for the exceptions, such as holidays.
NOTES
• To set schedules in a BACview® device, you must enable the Occupancy Schedules property on the Unit
Configuration screen. From the Home screen, go to CONFIG > UNIT.
• A network schedule downloaded from the i-Vu® application will overwrite a local schedule that was set up in
a BACview® device.
To set up a weekly schedule
You can set up a schedule and apply it to different days of the week. For example, you could set up one schedule
for Monday through Thursday, a second schedule for Friday, and a third schedule for Saturday and Sunday.
To set up a schedule:
1 From the Home screen, navigate to CONFIG > Sched > schedule_schedule > Weekly schedule > Mon (or any
day of the week), then press Enter. For help, see To navigate in a BACview® device (page 5) or To navigate in
a Virtual BACview® application (page 10). (page 10)
2 Define the time of each transition during the day from off (unoccupied) to on (occupied) and vice versa:
a) Highlight Add/Del, then press Enter.
b) Use the INCR softkey to change the value to Add, then press Enter.
c) The 12:00 am state is always the first transition. Change the 12:00 am state if it should be On. For help,
see To change a property in a BACview® device (page 5) or To change a property in the Virtual
BACview® application (page 10).
d) Highlight Add/Del, then press Enter.
e) Use the INCR softkey to change the value to Add, then press Enter.
f) Change the time and state of the new transition.
g) Repeat steps d through f until you have added all transitions for the day.
NOTES
○ To delete a transition, highlight Add/Del in that row, press Enter, use the DECR softkey to change the
value to Delete, then press Enter.
○ To create a 24-hour off or on schedule, define only the 12:00 am state.
3 Press the Continue softkey.
4 If the schedule applies to another day of the week, highlight the field below the day, press Enter, use the
INCR softkey to change the value to X, then press Enter.
5 Press the Save softkey.
To Next Page
Loading...