71
FACTORY 13H 1 //MAINMENU/CONFIG/
22 vfd_fdv 0 to 1 0 - VFD Feedback Voltage Sel 0 1
23 - 0-5V=0, 0-10V=1
24 dmp_auto 0 to 1 0 - Electrical Damper Valve 0 1
25 mrn_opt 0 to 1 0 - Marine Option 0 1
26 pr_opt 0 to 1 0 - Power Request Option 0 1
27 cpr_opt 0 to 1 0 - Cont. Power Request 0 1
28 Comp_pre 0 to 1 0 - 19DV Comp Design Press 0 1
- 44PSI=0, 72PSI=1
29 pg_opt 0 to 1 0 - Purge System Option 0 1
30 lqby_opt 0 to 2 0 - Liquid Bypass Option 0 2
31 - No=0, Full=1, Partial=2
CFGGEVFD 13H 2 //MAINMENU/CONFIG/
1 vfd_gain 0.10 to 1.50 0.75 - VFD Gain 0.1 1.5
2 vfd_max 90.0 to 110.0 100 % VFD Max Speed Per 90 110
3 vfd_min 50.0 to 89.0 70 % VFD Min Speed Per 50 89
4 vfd_str 65.0 to 100.0 100 % VFD Start Speed Per 65 100
5 vfdculm 0.0 to 99999.0 250 AMPS VFD Current Limit 0 99999
6 vfdc20ma 10.0 to 5000.0 200 AMPS VFD Load Current 20mA 10 5000
7 comp_100 45.0 to 62.0 50 Hz Comp Frequency 100% 45 62
8 vfd_ldap 0 to 1 1 - VFD Load Current Input 0 1
SERVICE1 13H 3 //MAINMENU/CONFIG/
1 ser_pass 0 to 65535 2222 - Service Password 0 65535
2 -
3 atom_pre 8.000 to 15.000 14.5 PSI Atmospheric Pressure 8 15
4 gv1_lim 30 to 100 80.7 % GV1 Travel Limit 30 100
5 gv1stpos 0 to 40 4 % GV1 Closure at Startup 0 40
6 ctrl_db 0.5 to 2 1 ^F Controlled Fluid DB 0.5 2
7 ewtdgain 1 to 3 2 - Derivatived EWT Gain 1 3
8 gv1decdb 2 to 10 6 - Proportional Dec Band 2 10
9 gv1incdb 2 to 10 6.5 - Proportional Inc Band 2 10
10 max_gv 1.0 to 4.0 2 % Maximum GV Movement 1 4
11 dem_20ma 10 to 100 40 % Demand Limit At 20 mA 10 100
12 dem_pdb 3 to 15 10 % Demand Limit Prop Band 3 15
13 ldramprt 5 to 20 5 % Amps or KW Ramp per Min 5 20
14 tmramprt 1 to 10 3 ^F Temp Ramp per Min 1 10
15 rcysh_dt 0.5 to 4 1 ^F Recycle Shutdown Delta T 0.5 4
16 rcyst_dt 2 to 10 5 ^F Recycle Restart Delta T 2 10
17 dmp_dly 1 to 5 2 min Damper Valve Act Delay 1 5
18 dmp_cldb 2 to 10 5 PSI Damper Valve Close DB 2 10
19 dmp_opdb 10 to 20 13 PSI Damper Valve Open DB 10 20
20 dmp_dt 4 to 10 7 ^F Damper Action Delta T 4 10
21 oilpvr_t 15 to 300 40 sec Oil Press Verify Time 15 300
22 sf_st_th 40 to 100 70 % Soft Stop Amps Threshold 40 100
23 wow_t 0.5 to 5 5 min Water Flow Verify Time 0.5 5
24 mbb_pfcl 0.5 to 2 1 - Power Calibration Factor 0.5 2
25 ex_start 0 to 1 0 - Enable Excessive Starts 0 1
26 oilstiro 0 to 3 1 - Oil Stir Cycle(19XR6/7) 0 3
27 - No Stir=0, 30s/30m=1,
28 0 to 3 - 1m/4h=2, Comb. 0&1=3
29 pgt_set 0 to 1 65 - Purge Active Temp SP 30 90
To Next Page
Loading...
