Carrier SUPRA 950Mt - Page 51

3-4
1.
1.
Pres
s the U
P or DOW
N ARR
OW key
to
increase or decrease setpoint. This is the same ope-
ration for
each compartme
nt.
b.
Set pre-
set set
point
The control pane
l allows the user to pre-set 5
differe
nts
temperatures on each compartment.
2.
3.
1.
Switch m
ain R
UN/STOP s
witch a
nd req
uired
remote compartment switches on the unit to RUN.
2.
Press Ca
rrier log
o and th
e lock l
ight wi
ll be d
is-
played.
3.
Pres
s host co
mpa
rtme
nt UP ARRO
W key for 10
seconds. P1 will be displayed in all compartments.
4.
Set lo
west se
tpoint
tempera
ture re
quired
.
5.
Press Ca
rrier log
o and P
2 will b
e disp
layed
.Set
next lowest temperature required up to five pre-set
setpoints are available.
6.
Pressin
g the s
econd
compa
rtment u
p or d
own
arrow will allow the lowest temperature required to be
preset in
the second compartment. Pressing Carrier
logo will then move on to the nest lowest (up to five).
7.
Press the
Carrier l
ogo for 1
0 secon
ds and th
is
will remove the lock light and store the pre-set set-
points in memory.
c.
Remov
e pre-s
et set
point
2.
3.
1.
Switch
main R
UN/STOP s
witch a
nd req
uired
remote compartment switches on the unit to RUN.
2.
Press Ca
rrier lo
go and
the lock
light wi
ll be d
is-
played.
3.
Press
host c
ompartm
ent u
p arro
w for
10
seconds. P1 will be displayed in all compartments.
4.
Set temp
erature
to lowe
st poss
ible a
nd OFF wi
ll
be displayed.
5.
Pres
s the UP ARR
OW key on re
mote c
omp
art-
ments will display the presets, take the temperature to
the lowest possible and OFF will be displayed.
6.
Press the
Carrier l
ogo for 1
0 secon
ds and
the
new information will be
stored in
memory
.
d.
Lock
the
cont
rol
pane
l
1.
2.
1.
Press th
e CARR
IER logo
until
it stops
flashi
ng.
It’s blocked when the light is on.
2.
The
ind
ica
tor c
ome
s on
.