157
APPENDIX A — LOCAL DISPLAY TABLES (cont)
MODE — CONFIGURATION (cont)
ITEM EXPANSION RANGE UNITS CCN POINT DEFAULT PAGE NO.
ECON ECONOMIZER CONFIGURATION
EC.EN Economizer Installed? Yes/No ECON_ENA Yes 22,62
EC.MN Economizer Min.Position 0 to 100 % ECONOMIN 5 22,26,27,62,69
EC.MX Economizer Max.Position 0 to 100 % ECONOMAX 98 22,47,58,62
EP.MS Economizer Position at Minimum VFD Speed 0 to 100 % EPOSMNFS 5 22,62
EP.XS Economizer Position at Maximum VFD Speed 0 to 100 % EPOSMXFS 5 22,62
E.TRM Economzr Trim For SumZ ? Yes/No ECONTRIM Yes 22,38,42,59,62
E.SEL Econ ChangeOver Select 0 to 3 (multi-text strings) ECON_SEL 1 22,27,59,62
DDB.C Diff Dry Bulb RAT Offset 0 to 3 EC_DDBCO 0 59,62
OA.E.C OA Enthalpy ChgOvr Selct 1 to 5 (multi-text strings) OAEC_SEL 4 22,59,62
OA.EN Outdr.Enth Compare Value 18 to 32 OAEN_CFG 24 22,59,62
OAT.L High OAT Lockout Temp -40 to 120 dF OAT_LOCK 60 22,59,62
O.DEW OA Dewpoint Temp Limit 50 to 62 dF OADEWCFG 55 22,59,62
ORH.S Outside Air RH Sensor Enable/Disable OARHSENS Disable 22,59,62
E.TYP Economizer Control Type 1 to 3 (multi-text strings) ECON_CTL 1 59,62
EC.SW Economizer Switch Config 0 to 2 (multi-text strings) ECOSWCFG 0 59,62
E.CFG ECON.OPERATION CONFIGS
E.P.GN Economizer Prop.Gain 0.7 to 3.0 EC_PGAIN 1 62
E.RNG Economizer Range Adjust 0.5 to 5.0 ^F EC_RANGE 2.5 62
E.SPD Economizer Speed Adjust 0.1 to 10.0 EC_SPEED 0.75 62
E.DBD Economizer Deadband 0.1 to 2.0 ^F EC_DBAND 0.5 62
UEFC UNOCC.ECON.FREE COOLING
FC.CF Unoc Econ Free Cool Cfg 0 to 2 (multi-text strings) UEFC_CFG 0 60,62
FC.TM Unoc Econ Free Cool Time 0 to 720 min UEFCTIME 120 60,62
FC.L.O Un.Ec.Free Cool OAT Lock 40 to 70 dF UEFCNTLO 50 60,62
T.24.C TITLE 24 FDD
LOG.F Log Title 24 Faults
Yes/No T24LOGFL
No 60,62
EC.MD T24 Econ Move Detect 1 to 10 dF
T24ECMDB
1 60,62
EC.ST T24 Econ Move SAT Test 10 to 20 %
T24ECSTS
10 60,62
S.CHG T24 Econ Move SAT Change 0 to 5 dF
T24SATMD
0.2 60,62
E.SOD T24 Econ RAT-OAT Diff 5 to 20 dF
T24RATDF
15 60,62
E.CHD T24 Heat/Cool End Delay 0 to 60 min
T24CHDLY
25 60,62
ET.MN T24 Test Minimum Pos. 0 to 50 %
T24TSTMN
15 60,62
ET.MX T24 Test Maximum Pos. 50 to 100 %
T24TSTMX
85 60,62
SAT.T SAT Settling Time 10 to 900 sec
SAT_SET
240 60,62
BP BUILDING PRESS. CONFIG
BP.CF Building Press. Config 0 to 3 BLDG_CFG 0 22,62,64
BP.RT Bldg.Pres.PID Run Rate 5 to 120 sec BPIDRATE 10 62,64
BP.P Bldg. Press. Prop. Gain 0 to 5 BLDGP_PG 0.5 62,64
BP.I Bldg.Press.Integ.Gain 0 to 2 BLDGP_IG 0.5 63,64
BP.D Bldg.Press.Deriv.Gain 0 to 5 BLDGP_DG 0.3 63,64
BP.SO BP Setpoint Offset 0.0 to 0.5 “H2O BPSO 0.05 63,64
BP.MN BP VFD Minimum Speed 0 to 100 % BLDGPMIN 10 63,64
BP.MX BP VFD Maximum Speed 0 to 100 % BLDGPMAX 100 63,64
BP.FS VFD/Act. Fire Speed/Pos. 0 to 100 % BLDGPFSO 100 63,64
BP.MT Power Exhaust Motors 1 to 2 PWRM 1 63,64
BP.S Building Pressure Sensor Enable/Dsable BPSENS Dsable 63,64
BP.R Bldg Press (+/-) Range 0 to 1.00 “H2O BP_RANGE 0.25 63,64
BP.SP Building Pressure Setp. –0.25 -> 0.25 " H2O BPSP 0.05 22,63,64
BP.P1 Power Exhaust On Setp.1 0 to 100 % PES1 35 22,63,64
BP.P2 Power Exhaust On Setp.2 0 to 100 % PES2 75 22,63,64
B.CFG BP ALGORITHM CONFIGS
BP.SL Modulating PE Alg. Slct. 1 to 3 BPSELECT 1 63,64
BP.TM BP PID Evaluation Time 0 to 10 min BPPERIOD 1 63,64
BP.ZG BP Threshold Adjustment 0.1 to 10.0 “H2O BPZ_GAIN 1 63,64
BP.HP High BP Level 0 to 1.000 “H2O BPHPLVL 0.05 63,64
BP.LP Low BP Level 0 to 1.000 “H2O BPLPLVL 0.04 63,64
D.LV.T COOL/HEAT SETPT. OFFSETS
L.H.ON
Dmd Level Lo Heat On –1 to 2 ^F DMDLHON 1.5 22,36,37,39,49,
52
H.H.ON Dmd Level(+) Hi Heat On 0.5 to 20.0 ^F DMDHHON 0.5 22,37,39,49,52
L.H.OF
Dmd Level(-) Lo Heat Off 0.5 to 2 ^F DMDLHOFF 1 22,36,37,39,49,
52
L.C.ON Dmd Level Lo Cool On –1 to 2 ^F DMDLCON 1.5 22,37,39,49,52
H.C.ON Dmd Level(+) Hi Cool On 0.5 to 20.0 ^F DMDHCON 0.5 22,37,39,49,52
L.C.OF Dmd Level(-) Lo Cool Off 0.5 to 2 ^F DMDLCOFF 1 22,37,39,49,52
C.T.LV Cool Trend Demand Level 0.1 to 5 ^F CTRENDLV 0.1 37,39,49,52
H.T.LV Heat Trend Demand Level 0.1 to 5 ^F HTRENDLV 0.1 39,49,52
C.T.TM Cool Trend Time 30 to 600 sec CTRENDTM 120 37,39,49,52
H.T.TM Heat Trend Time 30 to 600 sec HTRENDTM 120 39,49,52
DMD.L DEMAND LIMIT CONFIG.
DM.L.S Demand Limit Select 0 to 3 (multi-text strings) DMD_CTRL 0 26,42,43,107
D.L.20 Demand Limit at 20 ma 0 to 100 % DMT20MA 100 43
SH.NM Loadshed Group Number 0 to 99 SHED_NUM 0 26,43
SH.DL Loadshed Demand Delta 0 to 60 % SHED_DEL 0 43
SH.TM Maximum Loadshed Time 0 to 120 min SHED_TIM 60 43
D.L.S1 Demand Limit Sw.1 Setpt. 0 to 100 % DLSWSP1 80 26,43
D.L.S2 Demand Limit Sw.2 Setpt. 0 to 100 % DLSWSP2 50 26,43
To Next Page
Loading...
