CAS CI-200 Series - 5. Set Mode; 5-1. How to Enter the Set Mode; 5-2. Key Operations in Set Mode

31
5. Set Mode
5-1. How to Enter the Set Mode
Turn on the power while pressing key at the indicator front to start the Set Mode.
Or, Hold
key for about 3 seconds to move from other mode to the convesion mode.
After finishing the setup in the Set Mode, press
key for a long time
5-2. Descriptions on key operations in the Set Mode
~ : Use them to change the setup value.
: Save changes in the setup value and move to the higher menu
: Cancel the set value and move to the higher menu