CAS LP-II - System Configuration Options; Weight Options; Capacity and Units Configuration

8 System Options
25
8 System Options
8.1 Weight Options
< CAL: SYSTEM OPTIONS >
1. WEIGHT OPTIONS
2. NON-WEIGHT OPTIONS
3. KEYPAD OPTIONS
4. CLEAR MEMORY
5. SELECT COUNTRY
< CAL: WEIGHT OPTIONS >
1. CAPCITY & UNITS
Once at the CAL Main
menu screen, press the 2 key.
The System Options Menu screen
will appear as follows. At the
System Options Menu screen,
press the 1 key for Weight Options.
The Weight Options Menu
screen will appear as follows:
2. TARE OPTIONS
3. ZERO RANGE
4. CAPTIONS & HEADINGS
8.1.1 Capacity & Units
NUMERIC
< CAL: CAPACITY & UNITS >
Unit :[
1 ] 0)kg 1)lb
Capacity :[1] 0)15 1)30 2)60
Weigh Range :[1] 0)Single 1)Dual
Once at the Weight Options
Menu screen, press the 1 key for
Capacity & Units. The Capacity &
Units screen will then appear as
follows:
Unit: This determines the unit that
you will use to calibrate the scale
and it is the default unit that the s-cale will turn ON to when it goes into Sales mode. If you change this
value without re-calibrating the scale, you will get a “Calibrated Mass Error” every time you power ON
the scale.
Capacity: This determines the capacity for the scale. The LP-2 VER 1.03-USA is available in 60 lb/ 30 kg
only; however, the scale is programmable for 30 lb, 60 lb, 15 kg, or 30 kg.
Weigh Range: This determines the range for the scale & thus determines the minimum displayed
divisions. See chart below.
Capacity Weight Range (Single) Weight Range (Dual)
6 kg 0.000 kg ~ 6.000 kg X 0.002 kg (2 g) 0.000 kg ~ 2.999 kg X 0.001 kg (1 g)
3.000 kg ~ 6.000 kg X 0.002 kg (2 g)
15 kg 0.000 kg ~ 15.000 kg X 0.005 kg (5 g) 0.000 kg ~ 5.998 kg X 0.002 kg (2 g)
6.000 kg ~ 15.000 kg X 0.005 kg (5 g)
30 kg 0.00 kg ~ 30.00 kg X 0.01 kg (10 g) 0.000 kg ~ 14.995 kg X 0.005 kg (5 g)
15.000 kg ~ 30.00 kg X 0.01 kg (10 g)
15 lb 0.00 lb ~ 15.00 lb X 0.005 lb 0.000 lb ~ 7.498 lb X 0.002 lb
7.500 lb ~ 15.000 lb X 0.005 lb
30 lb 0.00 lb ~ 30.00 lb X 0.01 lb 0.000 lb ~ 14.995 lb X 0.005 lb
15.000 lb ~ 30.00 lb X 0.01 lb
60 lb 0.00 lb ~ 60.00 lb X 0.02 lb 0.00 lb ~ 29.99 lb X 0.01 lb
30.00 lb ~ 60.00 lb X 0.02 lb
NOTE: Any changes made here will affect the NTEP Audit Trail counters (OPT counter only.)