14 Servicing and Parts Replacement
54
14.7.6 Label Roll Spool Replacement
is OFF & that the scale
is unplugged.
center screw from label roll spool
5.
14.7.7 Wid
1. Make su ale is unplugged.
the Paper Guide Plate.
. Remove the Paper Guide Adjuster by sliding it out.
. Remove the screw at the base of the Width Adjuster chassis.
. Remove the Width Adjuster chassis and replace with new
Width Adjuster chassis assembly.
. Reassemble in reverse order.
4.8 Display Replacement
1. Make sure that the Main Power switch is OFF & that the scale is unplugged.
2. Remove the platter from the platform & all labels &
backing paper from the printer.
3. Remove the display stalk:
A. Unscrew the 2 screws from underneath the column base.
B. Lift & remove the display stalk from the column base.
4. Insert new display stalk and reassemble in reverse order.
1. Make sure that the Main Power switch
2. Remove all labels & backing paper from the printer
3. Remove
4. Remove label roll spool and replace
Replace center screw
th Adjuster Replacement
re th Power switch is OFF & that the scat the Main
2. Remove all labels & backing paper from the printer.
. Unscrew the 2 screws on the Width Adjuster & remove
3
4
5
6
7
1
To Next Page
Loading...
