CAS LP-II - Rewind Motor Assembly Replacement; Stepper Motor Assembly Replacement

14 Servicing and Parts Replacement
52
14 7.1 Rewind Motor Assembly Replacement .
. Follow all of the direction
. Unplug connector J16 on main PCB.
. Remove the Rewind Clamp.
. While holding the Rewind Support, unscrew the screw inside the its center.
. Remove the Rewind Support from the Rewind Joint.
. On the Rewind Joint, remove the 2 Allen-screws & pull out the Rewind Joint.
. d motor & remove it.
otor Bracket and then remove the Rewind Motor
assembly from the Printer Chassis.
. Reassemble in reverse order.
t
d replace with new Stepper Motor.
Belt.
.
1 s in section 0 first.
2
3
4
5
6
7 Unsolder the Rewind Motor Sub-PCB from the Rewin
8. Remove the 4 screws from the Rewind M
9
14.7.2 Stepper Motor Assembly Replacemen
1. Follow all of the directions in section 0 first.
2. Unplug connector J14 on main PCB.
3. Slide the Timing Belt off of the Feed Gear.
4. Remove the 4 screws that hold the Stepper Motor Bracket.
5. Remove the Stepper Motor an
6. It is suggested at this time to also replace the Timing
7 Reassemble in reverse order.