CAS NT-580A - Batching Operation Function

41
5-3-4. Batching Operation Function
F50
Function Measurement Mode
VFD Display DESCRIPTION
F50 0
Do not Use
F50 1 Normal batching
F50 2
Customer
Programmed
Control Mode
Loss-in-weight
batching
F50 3 Normal batching
Set Value
(0 ~ 4)
F50 4
Built-in automatic
program Mode
Loss-in-weight
batching
Plea※ se refer to each operation on Page 70.
F53
Function Timer - Start Delay Time
VFD Display DESCRIPTION
F53 00 No delay time
F53 10
1.0 sec
Set Value
(00 ~ 99)
F53 99 9.9 sec
Ref 1. . It is used only in the built-in automatic program Mode.
F54
Function Timer - Finish Signal Start Delay Time
VFD Display DESCRIPTION
F54 00 No delay time
F54 10
1.0 sec
Set Value
(00 ~ 99)
F54 99 9.9 sec
Ref 1. It is used to set the delay time of the finish signal after the batching operation..