Casio DT-X100 Series Software Manual

146
Error message list
The following error messages are used with backup/restoration processes.
(1) On backup
No. Error message Cause
1 An error occurred while writing the backup file. Check
that there is a memory card inserted, and that it has
enough free space.
Some files are left open and have
not been closed.
2 An error occurred while writing the backup file. Go
back to the menu, delete the existing backup file, then
try again.
Due to a lack of memory, writing
the temporary file for the backup
file became impossible before it
was complete.
3 The main battery has almost run down. Before
continuing with the backup, either replace the main
battery or recharge the battery.
A lack of battery capacity
prevented writing the backup file.
(2) On restore
No. Error message Cause
1 Could not write data. Data was not restored correctly. Due to a lack of memory, it was not
possible to replace the temporary
file for the backup file with the
backup file.
2 Could not read the backup file. Data was not restored
correctly.
The backup file is corrupted and
could not be read.
3 The main battery has almost run down. Before
continuing with the restore process, either replace the
main battery or recharge the battery.
A lack of battery capacity prevented
reading the backup file.
4 The password could not be confirmed. Be sure that
the password confirmation input exactly matches the
password.
The password input does not match
to the password of the backup file.

Casio DT-X100 Series Specifications

General

Brand	Casio
Model	DT-X100 Series
Category	Handhelds
Language	English