Casio DT-X100 Series Software Manual

57
2.9 Imager (1D/2D codes)
This section explains the specifications for scanning 1D and 2D barcodes.
2.9.1 Barcode scan specification
The symbols which can be scanned by the imager are as follows.
(1) 1D code (barcode)
Code
Scan
No. of
digits
Check
Character
(*2)
Check
Character
output (*2)
Other functions Remarks
EAN8/JAN8 8 (+2/5)
Always
enabled
Enable/
disable
2-digit/ 5-digit add-on
EAN13/JAN13 13 (+2/5)
Always
enabled
Enable/
disable
2-digit/ 5-digit add-on
UPC-A 12 (+2/5)
Always
enabled
Enable/
disable
NS output
2-digit/ 5-digit add-on
UPC-E 6 (+2/5)
Always
enabled
Enable/
disable
NS output
2-digit/ 5-digit add-on
UPC-A conversion
Code39
1~22
(0~48)
Enable/
disable
Enable/
disable
Start/stop bit output
switch
Full ASCII
conversion
Codabar (NW7)
2~26
(2~60)
Enable/
disable
Enable/
disable
Start/stop bit output
switch
Interleaved2of5 (ITF)
4~42
(4~80)
Enable/
disable
Enable/
disable
-
Code93
1~35
(0~80)
Always
enabled
Always
disabled
-
Code128/EAN128
(Code A/B) (*2)
1~28
(0~80)
Always
enabled
Always
disabled
-
Code A/B
Code128/EAN128
(Code C) (*2)
1~56
(0~80)
Always
enabled
Always
disabled
-
Code C
MSI (Plessey)
4~26
(4~48)
Always
enabled
Enable/
disable
-
IATA
4～24
（4～80）
Always
disabled
Always
disabled
-
Only a full
microwave
is possible.
Code11
1～40
（1～80）
Always
enabled
(2 digits)
Always
disabled
-
Only a full
microwave
is possible.
GS1 DataBar
Omnidirectional
(RSS-14)
14
Always
enabled
Always
disabled
-
GS1 DataBar Truncated
（RSS-14 Truncated)
14
Always
enabled
Always
disabled
-
GS1 DataBar Limited
(RSS Limited)
14
Always
enabled
Always
disabled
-
GS1 DataBar Expanded
(RSS Expanded)
1~40
(1~80)
Always
enabled
Always
disabled
-
ISBT (*1) 1~28
Always
enabled
Always
disabled
-
Code32 (*3) 9
Always
enabled
Always
enabled

Casio DT-X100 Series Specifications

General

Brand	Casio
Model	DT-X100 Series
Category	Handhelds
Language	English