193
OTHER SETTINGS
Use the following procedure to specify the rule that governs
generation of the serial number used in file names (page 181).
1. Press [MENU].
2. On the “Set Up” tab, select “File No.” and then
press [X].
3. Use [S] and [T] to select the setting you want
and then press [SET].
Specifying the File Name Serial
Number Generation Rule
To have the camera do this:
Select this
setting:
Remember the numbers used for files. Files
will be named using the next sequential
number, even if files are deleted or if a blank
memory card is loaded.
• If a memory card is loaded that already
has files stored on it and the largest
sequential number in the existing file
names is greater than the largest
sequential number remembered by the
camera, numbering of new files will start
from the largest sequential number in the
existing file names plus 1.
Continue
Restart the serial number from 0001
whenever all files are deleted or when the
memory card is replaced with a blank one.
• If a memory card is loaded that already
has files stored on it, numbering of new
files will start from the largest sequential
number in the existing file names number
plus 1.
Reset
To Next Page
Loading...
Need help?
General
