51
GETTING READY
The following are menu operations you will need to use to
configure camera settings. Take a few moments to become
familiar with them.
• See “Menu Reference” on page 247 for information about
menu contents.
• You also can use the Operation Panel (page 54) to configure
some of the settings that appear on the menu screen. In any
case where the same setting can be configured both on the
Operation Panel and on the menu screen, the Operation
Panel operation is always shown.
Example Menu Screen
Press [MENU] to display the
menu screen.
• Menu contents are different in
the REC mode and PLAY
mode. This screen shows the
REC mode menu.
Menu Screen Operation Buttons
The following is the procedure for menu operations in the REC
mode.
1. In the REC mode, press [MENU].
This displays the menu screen.
2. Use [W] and [X] to select the tab where the
item you want to configure is located.
Here, we will select the “REC” tab.
3. Use [S] and [T] to
select the item you
want to configure and
then press [X].
Example: Select “Focus” and
then press [X].
Using On-screen Menus
Tabs
Settings
[W] [X] Select tabs. [X] is also used to apply a setting.
[S] [T] Select a setting option.
[SET] Applies the selected settings.
[MENU] Exits the menu screen.
To Next Page
Loading...
Need help?
General
