232
USING THE CAMERA WITH A COMPUTER
■ Connecting the Camera to Your Macintosh
the First Time
1. Make sure the camera’s battery is fully
charged.
2. Turn on the camera, and then press [MENU].
• It makes no difference whether the camera is in a REC
mode or the PLAY mode.
3. Select the “Set Up” tab, select “USB”, and
then press [X].
4. Use [S] and [T] to select “Mass Storage”, and
then press [SET].
5. Turn off the camera, and connect the USB
cable that comes bundled with the camera to
the camera’s USB/AV connector and your
computer’s USB port.
• When connecting the bundled USB cable to the camera’s
USB/AV port, insert the plug into the port until you feel it
click securely into place. Failure to insert the plug fully
can result in poor communication or malfunction of the
connected components.
USB Port
USB Cable
Making sure that the W mark on the camera is aligned
with the X mark of the USB cable plug, connect the
cable to the camera.
USB/AV
connector
To Next Page
Loading...
Need help?
General
