Casio EXILIM EX-ZR400

37
Snapshot Tutorial
IMPORTANT!
• In the S mode, ISO sensitivity (page 45) always operates according to its “Auto”
setting. The ISO sensitivity setting cannot be changed while in the S mode.
• The flash > (Auto Flash) and ¥ (Red Eye Reduction) flash modes are not
supported while A, S, or M is selected for the recording mode. If you want the flash
to fire, select < (Flash On) as the flash mode.
• The displayed ISO sensitivity, shutter speed or aperture value will turn red when
you half-press the shutter button if the image is overexposed or underexposed.
M M (Manual Exposure) mode
This mode gives you total control over aperture and shutter speed settings.
1
Press [SET] to open the Control Panel.
2
Use [8] and [2] to select
A
(aperture).
3
Use [4] and [6] to change the aperture setting.
4
Use [8] and [2] to select
S
(shutter speed).
5
Use [4] and [6] to change the shutter speed setting, and then press [SET].
S S (Shutter Speed Priority) mode
In this mode, you select the shutter speed and other settings are adjusted
accordingly.
1
Press [SET] to open the Control Panel.
2
Use [8] and [2] to select
S
(shutter speed).
3
Use [4] and [6] to change the shutter speed setting, and then press [SET].
• You also can select the EV shift setting located under the shutter speed
setting and then specify an exposure value (EV shift), if you want.
A A (Aperture Priority) mode
In this mode, you select the aperture and other settings are adjusted
accordingly.
1
Press [SET] to open the Control Panel.
2
Use [8] and [2] to select
A
(aperture).
3
Use [4] and [6] to change the aperture setting, and then press [SET].
• You also can select the EV shift setting located under the aperture setting
and then specify an exposure value (EV shift), if you want.