Casio IT-G400 Series - Using a microSD Card

E-25
Using a microSD Card
This Smart Device supports micro SD cards.
The microSD card slot is located in the battery pack compartment, so you must remove the
battery pack before installing or removing a microSD card.
Installation
1. Turn the Smart Device off (shutdown).
2. Remove the battery pack.
(Steps 5 and 6 in the battery pack replacement
procedure on page E-16)
3. Push the microSD card into the card slot until it is
fully inserted, as shown in the fi gure.
4. Install the battery pack.
(Steps 3-5 in the battery pack replacement procedure
on page E-15)
Precautions for Use
• The front and back of the card are different, so the card must be oriented correctly
when inserted into the slot. Inserting the card incorrectly could damage the card
and/or the slot. Take care when inserting cards.
Removal
1. Turn the Smart Device off (shutdown).
2. Remove the battery pack.
(Steps 5 and 6 in the battery pack replacement
procedure on page E-16)
3. Pull the microSD card out of the card slot, as shown
in the fi gure.
4. Install the battery pack.
(Steps 3-5 in the battery pack replacement procedure
on page E-15)